Metal roofs in Trenton use 26 gauge galvalume panels or 24 gauge standing seam with hidden fasteners. These hold up when summers hit 90 plus and winters drop below freezing because the coating fights rust from the humidity. Cheap crews skip the thermal breaks and the panels buckle or leak at the seams after one bad freeze thaw cycle.
North Trenton and Chambersburg homes from the 1920s often have rafters spaced 24 inches that need extra strapping before metal goes on. Skip that step and you get oil canning and water under the panels during heavy summer storms. We pull Mercer permits on every job so the work passes inspection the first time.
Fastener choice matters here. We use stainless screws with EPDM washers instead of the cheap painted ones that fail in two winters. That single swap stops most leaks we get called out for in East Trenton and South Trenton after a contractor cut corners on material grade.
Call 609-555-0123 for a same day look at your metal roof. We answer 24/7 on leaks and storm damage and book installs Mon-Sat 7am-7pm.
Metal Roofing Services We Offer
✓Standing Seam Metal Roof Installation Trenton NJ
Full install using 24 gauge panels with hidden clips on homes in Mill Hill and Cadwalader Park area, done in four days.
✓Metal Roof Leak Repair Trenton NJ
Patch seams and replace bad fasteners on existing metal roofs before the next freeze cycle hits.
✓Emergency Metal Roof Repair Trenton NJ
Same day fix for wind lifted panels or storm leaks anywhere in Mercer county, available 24/7.
✓Commercial Metal Roofing Trenton NJ
installs on small commercial buildings using 26 gauge screw down panels that meet local wind load rules.
✓Metal Roof Replacement Over Shingles Trenton NJ
Tear off old shingles and lay new metal in one trip, common on North Trenton two story homes.
Metal Roofing Cost in Trenton, NJ
| Service | Typical Range | What Affects It |
|---|---|---|
| Metal roof install on 1200 sq ft house | $9,500–$14,000 | Price changes with panel gauge and roof pitch. |
| Standing seam upgrade on 1500 sq ft | $13,000–$18,500 | Hidden fasteners and better warranty add cost. |
| Emergency metal leak patch | $450–$950 | Depends on how many seams and height. |
| Commercial metal roof section repair | $1,800–$3,200 | Size of area and scaffold needs affect price. |
| Free metal roof estimate | Free | Call 609-555-0123 to book. |
Ranges are typical for Trenton, NJ and confirmed with an exact written quote before any work starts.
How it works
- 1
Site check and measure
Walk the roof and check rafter spacing plus any rot, takes one to two hours.
- 2
Material order and permit pull
Order panels and pull Mercer permit, three to five days lead time.
- 3
Tear off and underlayment
Remove old roof and lay ice and water shield plus synthetic underlayment in one day.
- 4
Panel install and trim out
Set standing seam or screw down panels, add ridge vent and flashings, two to three days.
- 5
Final walk and cleanup
Check every seam and magnet sweep for nails, same day sign off.
Pricing
Prices vary by square footage, access, and panel type. We give written ranges on site.